Upgraded UZB to 5.16 accidentally

[deg026]

i have also second z-uno device, that is still working
but it is flushing leds different when connect to USB PC
working one flush green+white
not worked flushing only green on connected to USB PC

[PoltoS]

White means the sketch is blinking with LED_PIN. On the second another sketch is loaded, so it do not blink

[PoltoS]

Try to hold service button and re-plug USB

[deg026]

ok, problem solved, but was not so easy....
just by luck i think to try setup battery power
then do "rescue mode"
and connect to USB
only then it become working and detext as UZB

else if i connect to usb and out "rescue mode" - windows do not retry to understand device (i have Win 7)
and if try to reattach then rescue mode lost

so, please write this into FAQ, think will be usefull for somebody!

[deg026]

Try to hold service button and re-plug USB

i have tryed, this helps too
thank you