forum

Hallo, how can i change the Parameter 14 of the Fibaro RGBW Controller, the Parameter ist not availible on my zway controller.

I con control the colors withe the dimmer switch for red, green and blue, but i can not control the colors with the color dimmer, the dimmer change the color to blue and green and no other color.

Hello,

Go to Expert Commands, then go to Configuration.
At this point you can get the status via Get and change the parameter with Set.
A review of the setting can be done by clicking on Configuration, you can see the setting has been adopted. Green means current. Red means it is no longer actual.


Z-Wave Support