wallc-s factory reset not working?
Posted: 13 Mar 2017 00:44
I have a WallC-S switch (don't know which version but it says Z-Wave plus on the back, takes 1xCR2032 battery and is 868Mhz. There are 4 black buttons on the front).
I originally connected it to a Razberry GPIO board on a Raspberry PI running the Z-Way software.
The board stopped working ages ago and I've now switched to using a UZB USB stick on a Raspberry PI running OpenHAB 2.
All my other devices work fine with OpenHAB2 (door sensors, LED lamps, smoke detectors) but I cannot get the WallC-S switch to connect to OpenHAB2. I presume the problem is because the wall switch is still bound to the old Razberry and so I decided to factory reset the switch. But I don't seem to be able to factory reset it:
I might have the wrong manual: The manual suggests I hold down the 4 buttons for 1 second to get into maintenance mode, but this seems to be wrong because I have to hold them down for 5 seconds before the light starts flashing green.
The manual then says press button 3 and then hold down button 4 for 4 seconds, but else where it in the manual it says to do this for 10 seconds... It's not clear whether I press and release button 3 before pressing button 4 or if I press and hold down button 3 and then hold down button 4. Either way, I don't think it's resetting: The green light starts flashing faster when I press and release button 3 but nothing happens when I then hold down button 4 - is there supposed to be any feedback from the lights?
I've confirmed that all 4 buttons work because the light flashes red when I press any one of the 4 buttons in normal mode.
Is anyone able to provide instructions on exactly what I have to do to reset the wall switch and what kind of feedback I should expect from the lights?
Thanks,
Simon
I originally connected it to a Razberry GPIO board on a Raspberry PI running the Z-Way software.
The board stopped working ages ago and I've now switched to using a UZB USB stick on a Raspberry PI running OpenHAB 2.
All my other devices work fine with OpenHAB2 (door sensors, LED lamps, smoke detectors) but I cannot get the WallC-S switch to connect to OpenHAB2. I presume the problem is because the wall switch is still bound to the old Razberry and so I decided to factory reset the switch. But I don't seem to be able to factory reset it:
I might have the wrong manual: The manual suggests I hold down the 4 buttons for 1 second to get into maintenance mode, but this seems to be wrong because I have to hold them down for 5 seconds before the light starts flashing green.
The manual then says press button 3 and then hold down button 4 for 4 seconds, but else where it in the manual it says to do this for 10 seconds... It's not clear whether I press and release button 3 before pressing button 4 or if I press and hold down button 3 and then hold down button 4. Either way, I don't think it's resetting: The green light starts flashing faster when I press and release button 3 but nothing happens when I then hold down button 4 - is there supposed to be any feedback from the lights?
I've confirmed that all 4 buttons work because the light flashes red when I press any one of the 4 buttons in normal mode.
Is anyone able to provide instructions on exactly what I have to do to reset the wall switch and what kind of feedback I should expect from the lights?
Thanks,
Simon