Add default power consumption?
Posted: 12 Jul 2017 09:26
Hi,
Some Z-wave devices had power metering built in, but some don't. However, if a switch is ON and there are 27Watts worth of attached lamps, then it is not difficult to know what will be the current power consumption, right.
Is there any way to incorporate this information in a Z-way system?
Fredrik
Some Z-wave devices had power metering built in, but some don't. However, if a switch is ON and there are 27Watts worth of attached lamps, then it is not difficult to know what will be the current power consumption, right.
Is there any way to incorporate this information in a Z-way system?
Fredrik