Page 1 of 1

Upgrading UZB on win10 box

Posted: 29 Nov 2018 03:18
by 3Cubed
Hi all, I just got my UZB stick and want to use it on my Windows10 PC. Whn i plugged the device in windows installed device drivers that was reported as working. Now I want to make sure im using the correct EU frq. and also if the UZB is not running the latest firmware, I also want to update it.

Now on to the problem. The instruction that came with UZB is extreemly poor. It sounds like I may need a software called Z-Way, but from the download page it's not available for win10 64 bit. in fact it's not available for anything but rasbarry!??

Any advice on how to update firmware and switch to to/check the frequenzy would be highly appriciated.

Thank's Kasper

Re: Upgrading UZB on win10 box

Posted: 29 Nov 2018 03:37
by 3Cubed
So I managed to find a windows install, didnt say what windows version it was made for but the file is this one:
I ran it but No software seams to have been installed? What is the purpose of this file then, it runs but does nothing!?

Re: Upgrading UZB on win10 box

Posted: 30 Nov 2018 14:25
by Z-Wave Support

The Windows version will not be further developed.

Best regards
Z-Wave Support