Expert UI: language, timing info, security
Posted: 05 May 2019 18:27
Hello,
I’ve got some questions about the Expert UI:
1. language
When I change the language (Settings- --> Language) it doesn’t remember this setting at my next login. It’s always English again. Is it a bug?
2. timing info
Under network --> timing info the legend says:
black: “Controller was not able to reach the given node with 3 attempts and tried a different route that finally worked“
What does different route mean? I only have battery powered devices which can’t act as repeaters. The packet sniffer also shows that no hops are used.
Red: “The communication finally failed after some re-routing attempts”
The sensor’s data sent at wakeup was completely received by the controller. How did it determine that the communication has failed?
3. security
Under device --> type info I see orange open lock symbols of Z-Wave Plus devices. What does that mean?
4. Controller in Lifeline Association
Under configuration --> association there is a red warning sign with an exclamation mark next to the controller. Is something wrong with it? And sometimes it’s named (#1.0) Z-Way and sometimes (#1) Z-Way.
I’ve got some questions about the Expert UI:
1. language
When I change the language (Settings- --> Language) it doesn’t remember this setting at my next login. It’s always English again. Is it a bug?
2. timing info
Under network --> timing info the legend says:
black: “Controller was not able to reach the given node with 3 attempts and tried a different route that finally worked“
What does different route mean? I only have battery powered devices which can’t act as repeaters. The packet sniffer also shows that no hops are used.
Red: “The communication finally failed after some re-routing attempts”
The sensor’s data sent at wakeup was completely received by the controller. How did it determine that the communication has failed?
3. security
Under device --> type info I see orange open lock symbols of Z-Wave Plus devices. What does that mean?
4. Controller in Lifeline Association
Under configuration --> association there is a red warning sign with an exclamation mark next to the controller. Is something wrong with it? And sometimes it’s named (#1.0) Z-Way and sometimes (#1) Z-Way.