Fibaro Switch 2 FGS-223 and motion sensor fgms-001

[Bryant417]

Hello,

I have a FIbaro Switch2 FGS-223 with Razpberry 2 SW. 3.0.4
Embed everything works wonderfully.

If I now want to set parameter 20 to 0, I always get an error message.
The switch always remains on the switch and does not become a button.

I've also tried using the expert menu. I don't get an error message there. Unfortunately, nothing changes.

I have the same problem with the Fibaro fgms-001 motion sensor and can save the value eg for LED from 81. But the LEDs stay on.

[PoltoS]

Make sure the value is applied. You might need to Force interview after setting this param