What firmware version do I have? (re: ZMESerialUpdater output inside...)
Posted: 09 Jun 2020 06:13
I've purchased a RaZberry2 and I'm currently exploring OpenZWave and Home Assistant but might also try Z-Way. (I'm not sure why Home Assistant doesn't support integration with Z-Way? It seems like great Z-Wave controller software...)
Regardless, I'd like to update the firmware if possible. Here is the output from ZMESerialUpdater:
It looks like the version is v05.25? If so, how do I decipher the map of available firmwares to see what I need to upgrade to? (I don't see 05.25 in the map)
Regardless, I'd like to update the firmware if possible. Here is the output from ZMESerialUpdater:
Code: Select all
Z-WAVE Serial API Tool
Version:LWE0.9
by Z-WAVE>ME
-->
Device ready in:3.06492495537 seconds
FULL INFO
Openning port .............................. OK
SERIAL INFO
VERSION: 05 25 VENDOR: 01 47
ZME_CAPABILITIES
UID: 98 36 A8 B4 9E 44 21 A3 0A 44 A1 98 DA 8B EA DD
VENDOR: 00 00 NODES: FF
FLAGS: 05 00 00 00 00 00 00 00 00 00 00 00 00
FIRMWARE CRC
BOOT: BB BB FW: C1 A5
MISC
FREQ: US
NVR Content
--------------------------------------------------------------------------------------------
Prog/erase lock : FF FF FF FF FF FF FF FF, Read back lock: FF
Rev 02, Cal 07, TXCal 15 11, SAW FF FF FF FF, Pin FF, CRC F3 C3
NMV: CS 04, TYPE 02, SIZE 01 00, PSIZE 01 00 (EEPROM M25PE20)
USB: VID FF FF, PID FF FF, UUID FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
--------------------------------------------------------------------------------------------
FACTORY ID: WEEK 26, YEAR 19, CHIP 06 AE, SER 93 FC, WS 111, HWREV: 00 05, CRC8 5B
elapsed 5.46522903442 seconds