forum

Hi,

I am new to Z-wave me, and have just inntalled a floor thermostat in our bathroom.
The Z-Wave "server" is a raspberry pi 4 with z-wave>me installed.
When I register the bathroom thermostat I get a list with several of the same item (like the one under)
Why? Have I registered the device several times, and can I just remove the redundant in the list?

The different versions does not always show the same values. Like different "ThermoFloor Temperature" (3.0? and 3.4). shows 19.9 and 24.1

Kind of confusing.

So which one should I keep and which ocurences should I remove?

Thanks
Helge


ThermoFloor Electric Meter (3.0)
ThermoFloor Electric Meter (3.0)
ThermoFloor Electric Meter (3.0)
ThermoFloor Electric Meter (3.1)
ThermoFloor Electric Meter (3.1)

ThermoFloor Temperature (3.x) (I have renamed the device - dont remember the original name)
ThermoFloor Temperature (3.4)

This happens because every value is in channels and ourside of channels. And some devices do not update one of the value. We are working right now on preparing a special integration of ThermoFloor. Will be ready in two weeks. Meanwhile just hide duplicates and those who don't update over time.

OK - thaks - will do!