forum

I added a First Alert ZCOMBO (CO and Smoke sensor). The interview was not done quite right (Security S2). I want to add the sensor again, but in standard ui the sensor is not visible but in expert ui it is. How can I remove the sensor completely so I can redo the inclusion?

Go to Add and on top press Remove button first.

Hi
Can you please tell me the steps you used and the setups to have First Alert show up in the z-way devices view? I can't seem to figure it out.

Thanks for your help
Naveen

How can I remove the sensor completely so I can redo the inclusion

Search here somewhere. There was a topic describing how to remove dead devices.
Shortly, from an Expert view you need to interview them. It fails. Then you can force removal.

Please help, i am also having the problem of removing the sensor. Let me try to solve the issue with the above recommendations.