forum

@PoltoS,

I think my RaZ board is dead.. when the raspberry boot the RaZ board LED is red and I can't use it!

Is there a way that I can use my spare board (for sure I'm not having a backup) without having to reinclude all the devices?

@PoltoS,

I finally managed to saved a lot of works by still having my old UZB paired to this network with an old backup!
Anyway, I managed to re-pair all the latest devices that I installed...

BUT, I'm having a couple of "dead" devices that I try to "delete" and they always come back and I'm having an error when deleting them.

Also, is the a way to do local backup of the config every day ?

Delete failed nodes from Expert UI

You can do local backup using curl - the request for backup is simple via API call.

@PoltoS,

Deleting from expert UI did nothing!

The device disappear from the list but come back again!

Here's something in the log while deleting

This means the chip was able to contact that device and marked it as alive back

@PoltoS,

I did the entire house, room by room to took the z-wave inventory, also made an excel document

And I have no idea where these device can be... I even check my invetory before the crash and those device ID was not used...

Is it possible that a device answer to 2 different ID ?

No, it is not possible. Though,... everything is possible in IT

Try to press Ping button on Status page and then remove again