Can't get the UZB to work, will work in openHab3
Posted: 16 May 2021 23:14
Hi,
my old trusty Vera Lite died a few days ago in my remote location. I look for a new Z-wave controller now, testing different ones in a demo. Long story short, I can't seem to get the UZB to work in Zway. I tried the pre-build images, different sd cards, Raspi 4, Raspi 1B+, a fresh buster with zway install via the usual command, I tried connecting the UZB before power, after power,... I see the UZB at /dev/ttyACM0 ... But whatever I do in the settings of the Zway "Z-Wave Network Access" app, the UZB won't be recognized, I have set the port to "/dev/ttyACM0". In expert mode, controller details, shows mostly blank...
In openHab3 on the same Raspberry 4 (different system image) the UZB works and I can control my demo setup. Is Zway not happy that the UZB has a network key and devices associated already to it? Homeassistant also works normally.
Is there something I am missing with the Zway setup?
//removed attachments, not relevant
my old trusty Vera Lite died a few days ago in my remote location. I look for a new Z-wave controller now, testing different ones in a demo. Long story short, I can't seem to get the UZB to work in Zway. I tried the pre-build images, different sd cards, Raspi 4, Raspi 1B+, a fresh buster with zway install via the usual command, I tried connecting the UZB before power, after power,... I see the UZB at /dev/ttyACM0 ... But whatever I do in the settings of the Zway "Z-Wave Network Access" app, the UZB won't be recognized, I have set the port to "/dev/ttyACM0". In expert mode, controller details, shows mostly blank...
In openHab3 on the same Raspberry 4 (different system image) the UZB works and I can control my demo setup. Is Zway not happy that the UZB has a network key and devices associated already to it? Homeassistant also works normally.
Is there something I am missing with the Zway setup?
//removed attachments, not relevant