Change from PI3 with Razberry Modul to PI4 with UZB Stick

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
donquixote0906
Posts: 13
Joined: 12 Dec 2017 17:21

Change from PI3 with Razberry Modul to PI4 with UZB Stick

Post by donquixote0906 »

Hello at all,
i want to change my PI3 with the Razberry Modul to a PI4 with a UZB Stick.
Is this still possible or are there technical limitations?

Is the way under Z-Wave Expert UI -> control -> start controller change the right way or
are there technical problems cause of the different hardware modules?

An other idea was to make a backup from the module (under Z-Wave Expert UI -> control ->)
and restore the data to the UZB Stick. Is it a valid solution?

Have anybody experience with such a process or are there other suggestions?

Thanks to all

Volker
User avatar
PoltoS
Posts: 7562
Joined: 26 Jan 2011 19:36

Re: Change from PI3 with Razberry Modul to PI4 with UZB Stick

Post by PoltoS »

Better to do it thru backup & restore
BlakeBernadette
Posts: 1
Joined: 29 Jun 2021 17:20

Re: Change from PI3 with Razberry Modul to PI4 with UZB Stick

Post by BlakeBernadette »

Yep, only backup is the best way!!
Post Reply