How to install a Zigbee (Conbee) stick parallel to z-wave stick on the same pi?

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
DrHeck
Posts: 5
Joined: 04 Jun 2019 16:50

How to install a Zigbee (Conbee) stick parallel to z-wave stick on the same pi?

Post by DrHeck »

Hello all,

does anyone have a Conbee USB stick running in parallel with the z-wave usb stick with the homebridge?
How do you install this? I didn't find anything about it by googling (only FHEM, hassio etc).
I have a Raspberry with z-way stick and z-wave running.
Now I would like to install the Conbee USB stick.
I tried this last year and after the installation z-wave did not run anymore, because the z-wave stick was not recognized.
After I unplugged the stick, z-wave ran again. Unfortunately, all devices and automations were gone in homekit (via homebridge-zway).

Before I try this again, I would like to know if anyone has this running....

Thanks a lot for any info.

Greetings,
Peter
rapheal
Posts: 1
Joined: 30 Aug 2021 19:01

Re: How to install a Zigbee (Conbee) stick parallel to z-wave stick on the same pi?

Post by rapheal »

hey,
USB module acting as a gateway between ZigBee devices and the main management center such as PC, laptop or Raspberry Pi. It works with Windows, Linux, and Docker systems. The gateway is compatible with hundreds of ZigBee devices and the list is constantly expanding. The module can be successfully used as an extension of an intelligent building system (e.g. Home Assistant, Domoticz or AI-Speaker) with ZigBee communication.

thanks!
Post Reply