How to install a Zigbee (Conbee) stick parallel to z-wave stick on the same pi?
Posted: 24 Jul 2021 19:25
Hello all,
does anyone have a Conbee USB stick running in parallel with the z-wave usb stick with the homebridge?
How do you install this? I didn't find anything about it by googling (only FHEM, hassio etc).
I have a Raspberry with z-way stick and z-wave running.
Now I would like to install the Conbee USB stick.
I tried this last year and after the installation z-wave did not run anymore, because the z-wave stick was not recognized.
After I unplugged the stick, z-wave ran again. Unfortunately, all devices and automations were gone in homekit (via homebridge-zway).
Before I try this again, I would like to know if anyone has this running....
Thanks a lot for any info.
Greetings,
Peter
does anyone have a Conbee USB stick running in parallel with the z-wave usb stick with the homebridge?
How do you install this? I didn't find anything about it by googling (only FHEM, hassio etc).
I have a Raspberry with z-way stick and z-wave running.
Now I would like to install the Conbee USB stick.
I tried this last year and after the installation z-wave did not run anymore, because the z-wave stick was not recognized.
After I unplugged the stick, z-wave ran again. Unfortunately, all devices and automations were gone in homekit (via homebridge-zway).
Before I try this again, I would like to know if anyone has this running....
Thanks a lot for any info.
Greetings,
Peter