forum

Dear,


I am using FIBARO MOTION SENSOR FGMS -001,
FIBARO KEYFOB FGKF-601,
DOOR/WINDOW SENSOR 2 FGDW -002,
BUTTON and some other 3rd Party Sensors.



I am using Silicon Labs Z-wave GECKO wireless Kit and for Z/IP Gateway i am using Raspberry pi 4.


I add the ZGM130S 700 Series END DEVICE in the Node List of PC Controller and I plugin the PC controller to USB Port of Raspberry pi 4 (Z/IP Gateway).

Z/IP Gateway converts z wave frames (3rd Party Sensors on/off data information) to IP traffic after setup Z/IP gateway and Z-Ware on Raspberry Pi to use Web server APIs but I want to output 3rd Party Sensors on/off information from Z/IP Gateway via UART to ESP32.


can you please help me how to create a custom client that runs on Raspberry pi (Z/IP gateway) for the above communication.

can you please assistance any example with what are the z ware C APIs i need to use to send the 3rd Party Sensors ON/OFF information to GPIO pin of Z/IP Gateway to ESP32 via serial.

with that i will try to do send out the battery percentage and some other requested services for other 3rd Party Sensors.

please help me how to convert the IP traffic of the 3rd Party Sensors Image and to send out from Z/IP Gateway via UART through GPIO Pins to ESP32.

I wait for your kind reply regarding this. thanking you.

Why not to use Z-Way instead of Z/IP ?