FIBARO FGRGBW-442 EU v5.0 almost unusable
Posted: 17 Sep 2021 23:37
Hi,
I use Qubino RGBW modules but they are really low quality - 2 out of 5 died on me. So I decided to try FIBARO, they manufacture IMHO good modules and they support S2.
I use it in network with 45 devices, but it is almost unusable, commands are slow and after 24h or so device stops responding. I have to restart Z-Way or force interview to make it respond again. It doesn't matter if the device is S2 or Unsecure included.
I have couple of Razberrys, firmware 5.39EU, Z-Way 3.2.0 (3.1.4 also tested), so I tested with stock Z-Way install, only FIBARO module included to the controller. I've made simple user module to switch RGB and W to random value every 10 seconds.
Attached is log and screen of filling queue. Can some shed some light on it? I'd really like to use this FIBARO module.
I can not see anything wrong within the log besides "Job is already marked as waiting for reply, Supervision overrides it - check encapsulated packet not to be a Get".
I use Qubino RGBW modules but they are really low quality - 2 out of 5 died on me. So I decided to try FIBARO, they manufacture IMHO good modules and they support S2.
I use it in network with 45 devices, but it is almost unusable, commands are slow and after 24h or so device stops responding. I have to restart Z-Way or force interview to make it respond again. It doesn't matter if the device is S2 or Unsecure included.
I have couple of Razberrys, firmware 5.39EU, Z-Way 3.2.0 (3.1.4 also tested), so I tested with stock Z-Way install, only FIBARO module included to the controller. I've made simple user module to switch RGB and W to random value every 10 seconds.
Attached is log and screen of filling queue. Can some shed some light on it? I'd really like to use this FIBARO module.
I can not see anything wrong within the log besides "Job is already marked as waiting for reply, Supervision overrides it - check encapsulated packet not to be a Get".