Fibaro Smart Implant

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
AlesKO
Posts: 84
Joined: 24 Nov 2016 09:58

Fibaro Smart Implant

Post by AlesKO »

For my project I would like to separate/dissconnect input (button) from output (relay).
Found solution by setting Protection Command Class > Local > 2. ("No operation possible – state of output cannot be changed by the B-button or corresponding Input. Inputs disconnected from outputs.")

So far OK, but z-way does not save this setting to the Smart Implant. What am I doing wrong ?
Post Reply