Page 1 of 1
Z-Uno shield and power supply
Posted: 21 Apr 2023 23:30
by Gbajolet
Hello everybody,
I have a technical question: I have a Z-uno shield and I want to utilize a 24 volts power supply.
To test my application, I need to modify the software, and for that I need the to transfer the program thru the USB connexion, I am afraid to burn my ZUNO shield, if I connect the USB connector with the 24 volts.
Do you have some experience with this?
Regards
Gilles
Re: Z-Uno shield and power supply
Posted: 22 Apr 2023 01:47
by PoltoS
The recommendation is to plug off the Z-Uno during the flashing. On the new Shield 2, we added a diode to make sure two powers don't harm
Re: Z-Uno shield and power supply
Posted: 22 Apr 2023 09:37
by Gbajolet
Thank you very much, I shall follow your advice
Best regards
Gilles
Re: Z-Uno shield and power supply
Posted: 02 Oct 2023 07:57
by Jammyha
Using a 24-volt power supply with a device designed for a lower voltage, such as the Z-Uno shield, can potentially damage the device if not properly handled. Here are some considerations:
geometry dash scratch
Check the specifications: Consult the documentation or specifications of the Z-Uno shield to determine its maximum operating voltage. Ensure that it can handle a 24-volt power supply. If the shield is not designed to work with 24 volts, it is not recommended to connect it directly to the power supply.
Re: Z-Uno shield and power supply
Posted: 19 Oct 2023 05:56
by PoltoS
Z-Uno 2 Shield can be powered from 12-24V
Re: Z-Uno shield and power supply
Posted: 05 Nov 2023 23:11
by qqflx2
From where can one buy Shield for Z-Uno 2?
Re: Z-Uno shield and power supply
Posted: 06 Nov 2023 04:40
by lanbrown