Problems replacing a failed node

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
temptemptemp
Posts: 1
Joined: 19 May 2023 18:51

Problems replacing a failed node

Post by temptemptemp »

Hello I am unable to replace a failed node......is there any help how to do it?
michaeldrennen
Posts: 1
Joined: 25 Sep 2023 11:39

Re: Problems replacing a failed node

Post by michaeldrennen »

You can try putting your Z-Wave controller/gateway into replace node or exclusion mode. Methods will vary by brand, but typically involve pressing and holding a button or switch on the controller for several seconds.
Post Reply