How to associate switches to EZmotion using RaZberry?

McD · Post by **McD** » 30 Mar 2013 02:06

In my network there is an EZmotion. The manual (http://www.expresscontrols.com/pdf/EZMo ... Manual.pdf) says

"Assigning associations to EZMotion will depend on the Primary Controller capabilities or the home-control application. Refer to the documentation for these devices on how to assign associations to EZMotion."

How do I set this association up in RaZberry?
Are there pages of documentation or config switches for this, which I have not seen?

Post by **PoltoS** » 30 Mar 2013 02:06

Please read the manual (section 7.4.3). You need to use drag&drop on the tab Device Configuration