Interconnecting devices

[Jose]

First, I have already included some devices in the Expert UI (port 8083); I have 2 sensors and 1 controller, specifically. Now, I need to connect these devices between them. I explain this:

For example, when "device number 1" is activated (1), automatically "device number 2" will be activated too. The purpose is getting information from the sensor and according to it control a motor.

My question is: how can I do it? I don't know how I can establish these rules in the interface Expert UI and I would like to know how far I can go with it.

Finally, that is too important because I'm finishing an important project in university, so any information about how I can get it may be useful.

Thank u a lot !!

[PoltoS]

Check BindDevices or LogicalRules in our new UI

[SolarFlor]

My question is: how can I do it? I don't know how I can establish these rules in the interface Expert UI and I would like to know how far I can go with it.

You can see here an example of Logica Rules
viewtopic.php?f=3422&t=20406&start=10#p51440

[Jose]

Where can I download this module and how I install it?

[pz1]

Install the latest 1.7.1, and you'll have it via the Home Automation UI

[Jose]

And how can I do it in "Home Automation UI"? "Logical Rules" module does not appear in modules list

[pz1]

Do you see any other modules under the selection list of menu Preferences/Automation?

[Jose]

Yes, like "Bind Devices", "Security Notifications" or "Web Camera" but it is not shown "Logical Rules".

On the other hand, I have recently installed it, but I don't know what my version is. How can I see it?

[pz1]

How can I see it?

One way to do it is by calling Z-Way configuration on port 8084:

Code: Select all

http://RaspBerry_IP:8084