Hi all,
I habe two battery powered sensor of Fibaro (Motion sensor and FGK-101 door / window). I could include and exclude the device pretty well, but the interview stage is not complete . I have reset the sensor manual, etc.!
Interview-Status
Door sensor - Device interview stage is not complete + ..+ +.++.....
Motion sensor - Device interview stage is not complete + ..+ +..++....+.
any ideas
Thanks
Maik
Device interview stage is not complete
Re: Device interview stage is not complete
Have you tried to wake up sensors duiring inclusion? (I have same sensors with full interview passed)
Razberry B+ 2.0.1-rc25 on ZW500 + 15 devices / Razberry B 2.0.1-rc25 on ZW300 for test
Re: Device interview stage is not complete
Or during Force-Interterviewdolpheen wrote:Have you tried to wake up sensors duiring inclusion?