Resolved latency

[pierre2302]

I had a problem of delay (5 to 10s) between the status change and press the button.

I realized (with timing info) a module had a very bad signal and disrupt the entire mesh.

I deleted the module and now I find a 2s delay between the button press and execution.

( 18 device in total )

[islipfd19]

That's all well and good, but what module did you delete? Perhaps it can be improved upon?

[pierre2302]

This is not a problem of the device, but its distance with Razberry. This disturbed the whole Zwave mesh.