New version of RaZberry is released

Discussions about RaZberry - Z-Wave board for Raspberry computer
klirichek
Posts: 41
Joined: 02 Nov 2012 14:53

'All on' and 'All off' in web ui?

Post by klirichek »

Just curious if any plan to support them?
I know that these buttons were there before 1.4.1, but actually they never works (just fired 'internal server error' being pressed). Now I see that they are completely removed.

So, is any way to invoke the command from RaZberry iface?

klirichek
Posts: 41
Joined: 02 Nov 2012 14:53

Wow... It sounds like explanation...

Post by klirichek »

I just noted that such command being sent from other devices is not always reach all of them. Especially from remote controller to the switch in opposite corner of the big area.
However this is not a big problem (not reach now? Well, I click 'switch off' one more time).

klirichek
Posts: 41
Joined: 02 Nov 2012 14:53

Assign different names to Fibaro dual switch

Post by klirichek »

Right now two channels of Fibaro dual switch are just "Name #1" and "Name #2".
Does it possible to customize these names? Ideally - to assign a different name to each of the channel.
Say, if I have double switch for Toilet/Bath - it is s little unusual to have some "#1" and "#2" switches, and literal name for each if it would be much more comfortable.

Post Reply