Page 1 of 1
Thermostat
Posted: 21 Mar 2013 00:47
by pacaj2am
Hello,
I just wonder howto change thermostat setpoint for my thermostat. I would assume, that command:
http://raspberrypi.lan:8083/ZWaveAPI/Ru ... figSet(27)
would change the value to 29 Degrees. But I receive error. I tried both userSet and configSet.
Could you, please, help?
Thank you
Jan
Which thermostat do you have
Posted: 21 Mar 2013 00:47
by pz1
Which thermostat do you have? In case it is a Danfoss Living Connect, remember the temperature setting range is 4-28 Centigrade.
yes
Posted: 21 Mar 2013 00:47
by pacaj2am
Danfoss... Oops... I spent several hours...
I'm still not sucessfull
Posted: 21 Mar 2013 00:47
by pacaj2am
Even with lower temperature, that is in range.
the method is called Set, not
Posted: 21 Mar 2013 00:47
by PoltoS
the method is called Set, not configSet. Please check the manual on the razberry.zw-ave.me site.
i found solution... :-)
Posted: 21 Mar 2013 00:47
by pacaj2am
razberry.lan:8083/ZWaveAPI/Run/devices[5].instances[0].commandClasses[67].Set(1,23)
this sets the Danfoss Valve to 23°C... Even 22.5°C works...
I have still question
Posted: 21 Mar 2013 00:47
by pacaj2am
null is returned. Is that correct?
Yes, it is. The function
Posted: 21 Mar 2013 00:47
by PoltoS
Yes, it is. The function returns nothing if succeed and an exception is case of error
ok, super... i will bring
Posted: 21 Mar 2013 00:47
by pacaj2am
ok, super... i will bring decision logic on it...
thank you
jan