forum

Hi,

the MultiSensor will not be recognized.
Last time I could include it - it will be added as Aeon Labs Routing Binary Sensor.
Changing the device type will allow to set up the device - but all values will be mixed up in the demo GUI - in Log is all fine.

Just now - I can not change the device type - the opened window will show only empty pull-down menu.
What happen?

And - when it will be supported as regular device?
(customers can buy it at any shops since some time - like zwaveeurope.com)

Best regards
Michael

This device will be supported out of the box with next release. Changing the "type' of device does nothing except for verbal descriptions.

Hi,

I have changed the device type now via "Device Description Record" - and was able then to set the "Configurations" (you should wait some time, after rerequest interview and wake up it will be available)
But the values are mixed up in sensors device control table ...

Anyway - will wait for the update - thanks!

confirmed - Multisensor is supported now, thanks!