forum

Hello Everyone,


I wanted to start a topic on the progress that I am having on installing a Z wave lock that is controlled by a Raspberry pi with the RaZberry installed.
I have set up my Pi with Raspbian "Wheezy" and installed the RaZberry. I also was able to load the Zway software and get it running. I then tried to connect the lock and seem to have trouble there. The lock will not send a signal. I'll have to send it back and try another one. It is a Kwikset with home connect.

My goal is to be able to assign lock codes from a website where I can change the duration and days.

More when I get a new lock



Hobs

Hello,

I was able to get the lock working. Apparently it was on another network and needed to be excluded and the n included.
I an now working on a new interface that meets my requirements.


Hobs

We are very interested by your solution! Would be nice to see it!