forum

I have a network with 20 or so dimmers and switches, and one fibaro door sensor and an energy monitor. I can happily send commands to every device, but none of the devices seem to send information back to the RaZberry - or the RaZberry is not listening for it. I have a light switch 2m away from the controller, and when I turn it on, the RaZberry never notices that it has been turned on. I have to press Update for it to poll the switch. Similarly, the door sensor never gets triggered - it is noted as last updated shortly after I installed it.

Do I need to do something to make sure it listens to the switches and sensors?

Martin

Please check that all your devices have a group to report state changes (not all devices support this) and that these groups contains RaZberry (i.e. these devices are associated with RaZberry NodeId)