forum

Hi guys,

I just bought RaZberry and successfully installed Z-Way software on it. It works as it should, but I missed the automation tab. As I see - where is no automation in my version of Z-Way. I found the Z-Way version installed in my system is 1.3.1. But automation advertised in 1.4. So there can I get 1.4 version with automation support as advertised on your home page?

Thanks.

It has not yet been released. There is no release date published either.

 The advertising clearly states version 1.4 on the home page:The new RaZberry Controller Software Version 1.4 now supports JavaScript based Automation and Scripting. Check out more details here or you straight to the RaZberry Home Page.

Yes, I know that space, and a I know about the discrepancy w.r.t. versions. It is their new website released a couple of weeks ago. Apparantly due to new problems with the software, website and download are not in sync. With the new website the roadmap also disappeared. So the only thing you can do is wait until they explain things in this forum.
note: the instruction for the initial installation is the same as for getting the latest version. There is a 1.4 RC available, but that seems to have some nasty flaws in it. IIRC it did not have the automation tab either.

Ok, I'll wait for official answer, I bought my razberry because of this automation advertised.

I understand your frustration. I am waiting for answers too

Now v1.4 is out!

1.4 with automation tab?

The "blue" UI will ever get automation tab like it was in Z-Cloud. Current automation engine has no setup UI yet. But will soon. For now read this: http://en.z-wave.me/content/home-automation-engine