Page 1 of 2
Error: method_guiInit: values[] size differs from number of parameters!
Posted: 27 Sep 2013 13:57
by garp
When clicking a device in the Expert interface (
http://IP:8083/expert/), i get an error message: method_guiInit: values[] size differs from number of parameters!
The device i am controlling is a greenwave reality smart powernode.
For a screenshot see
https://www.dropbox.com/s/s77ou94kr1gbp ... Z-wave.jpg
There seems to be a
Posted: 27 Sep 2013 13:57
by PoltoS
There seems to be a problemwith interview. Make a backup and send it to us with a short note about the problem.
I have exactly the same
Posted: 27 Sep 2013 13:57
by rdnzl
I have exactly the same problem, did a fresh exclude/include of the powernode, but error stays.
At first reading of the instances for this device was also messy (it reported instance number 96 for example), but this has cleary after a while they now are numbered 1-5 again.
Were to mail the backup too?
Btw, forgot to mention that
Posted: 27 Sep 2013 13:57
by rdnzl
Btw, forgot to mention that it worked ok in Z-Way 1.3.1, so it's an 1.4 issue...
Where should i send the
Posted: 27 Sep 2013 13:57
by garp
Where should i send the backup to?
Additionally, it appears thet
Posted: 27 Sep 2013 13:57
by garp
Additionally, it appears thet renaming devices doesn't 'stick', maybe that's releated to the issue?
Any update on this issue?
Posted: 27 Sep 2013 13:57
by alexie
Any update on this issue?
Fixed in v1.4.1-rc1. We can
Posted: 27 Sep 2013 13:57
by PoltoS
Fixed in v1.4.1-rc1. We can not check it, since we have not such a device. Please give a try and report us back
Sorry for the late reply, i
Posted: 27 Sep 2013 13:57
by alexie
Sorry for the late reply, i will test it this week.
Re: Error: method_guiInit: values[] size differs from number
Posted: 14 Mar 2014 12:42
by sonnyboy
im using 1.5.0.rc3 and the issue is still there.
Any suggestions?
