forum

The post about the new version (v1.4.1-rc1) indicates support for alarm command code, but i still see this in my logs after upgrading:

[2013-10-29 07:52:47.379] Node 2:0 CC Security: Got secure frame, but Command Class 0x71 isn't registered, instantiating it as not supported
[2013-10-29 07:52:47.380] Trying to create command for unknown CC 0x71
[2013-10-29 07:52:47.381] Command Class 0x71 is not supported (requested for node 2:0)
[2013-10-29 07:52:47.381] Node 2:0 CC Security: Command Class 0x71 isn't implemeted

Do i need to do something else like re-interview my door lock? Where did the button to force the interview go?

Device configuration, scroll all way down on page on right side, select advanced actions and you will find the button

Didn't realize the little section headers were also buttons to hide and show actions!