forum

Hi,

I got Razberry with one module fibaro dimmer FGD 211, regulary the module is disconnected from zway program.
I got this message "The device seems to be dead", i only successfully connected the module 4 hours straight.

Configuration :
Raspberry PI model B
Razberry card
FGD211 dimmer

Raspian '2014-01-07-wheezy-raspbian.zip' default.

Tested :
domoticz image (pb to integrated zway library, after reboot zway en domoticz software not running)
Zway on raspian + domoticz work but module disconnect.

I tried many possibility but no one seem to work correctly.
like mentionned in another post does fibaro/chip is fully compatible with razberry ?

Regards,
Nicka

Just for info i will try to install the last version v1.5.0-rc1 and i will report if something change.

Do you have some update on this ?
I'm also experiencing that problem with my roller shutter from aeotec.

I did setup cronjob to shut up and down , and it hangs every 2 cycles.

yeah finally sent back my razberry to vendor, i wait a new razberry.
There is some razberrry with problem. you can contact your vendor.

I also change client, now i use jeedom and this one for me is better.