forum

during all my trials with Z-Way I have included and excluded more times the same device (Fibaro Plug).
At the end now I have 3 devices but only one is a real one.

How I can remove the 'false' devices?
thanks

Anybody to help?

Probably, in network section, reset the controller and reinclude all the devices.

If they are marked as failed or dead by the system you remove failed nodes under "network management".

It seems I cannot select "Remove Failed Node"

You need first to enable Expert mode and in Device Status tab press Test Connection button. Then go to Network Management and Remove them as Failed.

I did but doesn't work

Was it maked as Failed?

Please see attached the situation on Device 2 (one of the ones that I would like to remove).
I'm in Expert mode.

Hi,

have you tried this?

PoltoS wrote:You need first to enable Expert mode and in Device Status tab press Test Connection button. Then go to Network Management and Remove them as Failed.

It is not possible that the same device is online with different IDs

Michael