Page 1 of 1
Devices not visible after "Reset controller"
Posted: 11 Apr 2014 12:45
by jgrabowski
Hi,
One of my developers pressed "Reset controller", before reading docs ;-( It caused huge problems because we cannot see devices that were previously included. How could we revert back to "zero state"?
Regards,
Jakub.
Re: Devices not visible after "Reset controller"
Posted: 15 Apr 2014 01:43
by PoltoS
Reset Controller is the return to "zero state"
Not kidding, really!
If you have made a backup, you can restore this back, but only if your developers pressed that button before resetting
Re: Devices not visible after "Reset controller"
Posted: 15 Apr 2014 12:13
by jgrabowski
Ok, and what if he didn't make a backup before?
Re: Devices not visible after "Reset controller"
Posted: 16 Apr 2014 23:22
by PoltoS
You are unlucky
It is like making "format c:" or "rm -Rf /" without making a backup.
There is still a hope that the xxxxxxxx-DeviceData.xml is still there and this can help to restore all the data, but I assume that if it was a network of your developers, it is easier to just rebuild from scratch (I assume it is a test network)