forum

Hi,

I read thru all the guides and went set by set doing the install of the zwave board onto my pi. I have several devices that the software UI should be seeing but I am not getting anything. It looks like it sees my raz but nothing else.[img]Screen%20Shot%202014-05-01%20at%205.43.13%20PM[/img] I am just seeing this error on the network page."to configure controller behavior use home automation (not implemented yet).
Any ideas?

thanks,

anthony

no screenshot attached. have you included devices?

I tried to but when i hit to include nothing includes. I know the devices work since they were hooked up to an older wave verizon controller.

You probably need to exclude them first (since they're associated with another home ID), and then include them.