forum

Hi,
Im new here, so i already thanks you for helping me

Platform :
Raspbery with the last Raspbian.
RaZberry with v1.7.1-rc1

My problem... I include my Fibaro Motion Sensor, everything is okay, i have the 2 sensors (Temp/Lux), but if the device go to the sleep state, The sensor will never be recognized by the controller... I try to exclude him... but nothing.
If i include them again, the sensor is added but with a new ID...

I think the id of the device are not save... it's possible ?! Somebody have encounter the same issue ?

Thxx

Check your RaZberry manufacture date. If it is middle of April, you'll need to replace it.

Oh....

Indeed... 14 April.... what is the problem with this Razberry ?

There was a batch of RaZberries with broken EEPROM in April. Unfortunately, not all of them were revoked in time.
Please contact your reseller for replacement.

where exactly is the date printed?

sdh wrote:where exactly is the date printed?

It is printed on the other side of the board, approximately under antenna.

This morning my Fibato Motion Sensor (device 7) invented a new device called 'tank capacity' and the measure is 1 cube meter
What is it?
May I remove it?

We have seen this from time to time. Looks like corrupted packet (due to RF or problem in the device - first is more probably). Can you show us the log where it comes first time? (search for "cbm" line).

could you remind me where the log file is?
thanks

/var/log/z-way-server.log