What is backup/restore supposed to do?
Posted: 31 Jul 2014 15:47
Apologies if this has been asked before, but as the forum search is seldomly available, I can't check if it has been addressed. Also the Zway manual says "TODO" for backup/restore.
The point is that I want to start with a clean installation. So-far I have been working with derivatives of 1.3.1.
In my installation I observe all kinds of weird errors for which I can't find the cause. For example after a couple of days running I find that my system hangs and will not restart. Or in a couple of other cases I could not shutdown the Pi, because somehow system files were corrupted. I could see the commands in the directory view, but all specifics were question marks. These instabilities coincide with the the use of the new OpenRemoteHelper modules and version 1.7.x instead of using the older RaZ-OR modules.
Anyhow a couple of days ago, with the Expert GUI, I made a backup of a freshly installed 1.7.1 with all devices functioning en properly included. On the RaZberry site I discovered a complete image wbased on version 1.7.1.
I wrote that image to my SD card, and it started nicely. Of course not with my background images.
So I decided to restore the backup. It started and said something like "wait to complete". I did wait for over an hour still not completed. So I refreshed the screen. All devices had lost their configuration. Force re-interview did not work.
As said by the lack of a manual I just did what looked sensible. Apparantly I did something wrong. But what?
The point is that I want to start with a clean installation. So-far I have been working with derivatives of 1.3.1.
In my installation I observe all kinds of weird errors for which I can't find the cause. For example after a couple of days running I find that my system hangs and will not restart. Or in a couple of other cases I could not shutdown the Pi, because somehow system files were corrupted. I could see the commands in the directory view, but all specifics were question marks. These instabilities coincide with the the use of the new OpenRemoteHelper modules and version 1.7.x instead of using the older RaZ-OR modules.
Anyhow a couple of days ago, with the Expert GUI, I made a backup of a freshly installed 1.7.1 with all devices functioning en properly included. On the RaZberry site I discovered a complete image wbased on version 1.7.1.
I wrote that image to my SD card, and it started nicely. Of course not with my background images.
So I decided to restore the backup. It started and said something like "wait to complete". I did wait for over an hour still not completed. So I refreshed the screen. All devices had lost their configuration. Force re-interview did not work.
As said by the lack of a manual I just did what looked sensible. Apparantly I did something wrong. But what?
