forum

In my experiments, I excluded and delete nodes a few time, but when ever things get reinclued a fresh number is always used. Is there a way I can renumber the nodes to yes the low down dead space/put them in an order I like?

No, you cannot.
The only way is to reset the controller and then re-include all the nodes once again.

I feared that might be the case, any way to tell the controller the next number it should use when things are inclued? Though the point seems a bit mute now, as my razberry decided to stop working when I restarted my rasberry pi over the weekend So I guess I will be setting up a new network anyway.