forum

I have a Raspberry Pi B running Raspbien (Debian 7.8) with a Razberry hat and that's working well. I recently tried to upgrade that system to a Pi 2 B by cloning the SD card to a MicroSD and moving the Razberry hat over. This basically worked, but communications between it and my light switches was barely functional. I made sure to be using a 2 A power supply instead of the 700 mA power supply I was using on the Pi B. I tried removing z-way entirely from the system and reinstalling, resetting the entire Z-Wave network, etc. I upgraded the latest 2.0.1-rc (v33). No joy. Any thoughts on this?

Additional info:
There is some other software (Java program, I know, sue me) running on the Pi in both scenarios. I also have Webmin 1.750 running.

This is not working. I had to setup the installation manually. No IMG is working. Install the latest Raspberry image and than install the z-way software. This worked for me. I can run the SD card on both units. Old B unit and the 2 B as well. Good luck

Yea I always install manually. I'm thinking this must be a power issue.