No device description after update to z-way 2.0.1
Posted: 02 Jul 2015 00:31
Hi,
after installing z-way server 2.0.1 on my razberry it is not possible to set device description for my Fibaro wall plugs. This means that the hardware configuration page is empty.
In the expert UI I am able to select a device description:
But pressing "select" has no effect and the following is written to the log:
With 2.0.0 it was possible to select a device description, so I tried two things:
- I copied the old ZDDX directory
- I did an update of the ZDDX dir with UpdateXMLs.sh
Both of them did not solve the problem. Does anyone has an idea how to set the device description and to get back the hardware configuration page?
Regards,
Oliver
after installing z-way server 2.0.1 on my razberry it is not possible to set device description for my Fibaro wall plugs. This means that the hardware configuration page is empty.
In the expert UI I am able to select a device description:
- device selection
- selection.jpg (58.88 KiB) Viewed 5635 times
Code: Select all
[2015-07-01 23:10:24.385] [I] [zway] Loading ZDDX index from ZDDX/ZDDX.indxml
[2015-07-01 23:10:29.214] [D] [zway] SETDATA devices.3.data.ZDDXMLFile = "undefined"
[2015-07-01 23:10:29.214] [I] [zway] Saving configuration data to config/zddx/fb9a3715-DevicesData.xml
[2015-07-01 23:10:29.438] [I] [zway] Loading ZDDX data from ZDDX/undefined
- I copied the old ZDDX directory
- I did an update of the ZDDX dir with UpdateXMLs.sh
Both of them did not solve the problem. Does anyone has an idea how to set the device description and to get back the hardware configuration page?
Regards,
Oliver