forum

The heatit thermostat seems partly supported, but there is no device description xml

Yes, we have not tested them yet. You can contribute and send the ZDDX

PoltoS wrote:Yes, we have not tested them yet. You can contribute and send the ZDDX

The xml file created by the "ZDDX Code Creator" in the expert mode?

Seems, that the "Multireg Z-Wave electronic thermostat with 4 functions" matches. Is this right?

I am planning to buy some HeatIt thermostats.

Is it now fully supported in Z-Way?

If not, then which parts are working and which parts do not work?

PoltoS wrote:Yes, we have not tested them yet. You can contribute and send the ZDDX

Hi! Here is the requested file.

Is a description file needed or is there a generic one I can use instead?

Thank you and best regards!

Please check
http://pepper1.net/zwavedb/device/990

aivs wrote:Please check
http://pepper1.net/zwavedb/device/990

Great thank you! But sorry for asking, how can I add this data into my installation? I've been looking around google and this forum but I cannot find any instructions.

user12esy wrote:

aivs wrote:Please check
http://pepper1.net/zwavedb/device/990

Great thank you! But sorry for asking, how can I add this data into my installation? I've been looking around google and this forum but I cannot find any instructions.

At the lower left bottom of the pepper1 page there is a link to the z-wave
Save that file in folder /opt/z-way-server/ZDDX. Restart Z-way and your device should be there (I think, since I haven't tested this)

It will be added in next release.