forum

I created a Device Association App and mistakenly configured the samed devices in the IF and THEN parts. Now the lights turn on and off quickly. Unfortunately, this also seems to block the user interface, so I don't get any response at all when browsing to <ip>:8083.

Is there I way to somehow break this loop and/or delete the incorrect app from the shell? (I do have ssh access to the raspberry, just don't know what to change...)

Thanks for your support,
Thomas

Ok, I've reinstalled the entire Razberry from the factory image. As the devices were all stored in the Z-Wave board, I did not need to reinclude them.

Next time try to roll back to previous backup or just remove the app in automation/storage/configjson-xxx.json