forum

Hi,

yesterday I included a Room Thermostat from Danfoss into Z-Way. The interview was successfull except for 2 Command Classes: ThermostatSetPoint and Version. This device supports the ThermostatSetPoint V3 and if I look deep into the traces it seems there is a misinterpretation of the values delivered by the Danfoss RS.
Attached the following:
- Screenshot from Expert UI about interview
- Log from Z-Wave debug log (lines from 118 to 121 is where I suspect the issue is)
- link to the Specification of the Danfoss RS: http://products.z-wavealliance.org/products/1062

Thanks and regards

I get exactly the same problem.

Have you found a solution or workaround?