forum

Hi all

First post here,and first adventure with Z-wave, as I try to replace some old X10 gear.

I have a Raspberry Pi running Domoticz, and have just bought a Razberry board.
I've set this up and added it as a device in Domoticz, looks OK as far as I can tell.

I have one Z-wave device that I am trying to include, a Fibaro FGD-212 dimmer (EU version).

In Domoticz, I try to include the node, and I set the FGD-212 up for inclusion, eitherby pressing my (retractable) wall switch quickly 3 times, or the "B" button quickly 3 times.

The LED lights red on the Razberry board - but then nothing happens. The dialog in Domoticz stays open, waiting for the device to include, but this never happens - the only option is to abort. When I do abort, the red LED on the Razberry goes off.

Any ideas what might be the issue ?

When I press the B button 3 times quickly on the Fibaro, should the LED on the Fibaro dimmer light up ? (It doesn't - just don't know if it should or not)
How can I be sure I've got the EU version of the Razberry ? The crystal seems to be marked "U" but I'm not sure what that indicates.

Thanks for any suggestions. Hopefully it's just me doing something daft...

Since you are not running ZWay, you better ask the guys on Domoticz forum

Thanks, I have done.

Any ideas how I can confirm if I've got the EU or US version of Razberry board though?

muddymickey wrote:Any ideas how I can confirm if I've got the EU or US version of Razberry board though?

In the ZWay software you could see it via Expert User Interface menu /network/Controller Info

Does anyone know if the letter "U" on the crystal indicates EU or US frequency?