Page 1 of 1
Upgrdae firmware of RaZberry using Domoticz
Posted: 18 Feb 2016 13:06
by Muckydevil
Hi,
I'm using Domoticz with Razberry on a serial port. Domoticz is reporting the firmware as Version: 1.3-523-gb258e9e. Is there a command line too I can use to update this firmware?
Re: Upgrdae firmware of RaZberry using Domoticz
Posted: 18 Feb 2016 13:14
by pz1
Re: Upgrdae firmware of RaZberry using Domoticz
Posted: 18 Feb 2016 13:34
by Muckydevil
Hi,
Thanks for the reply. The link below indicates that you need to install this software with its own web server? Is that the only way as I was try to avoid installing anything else except Domoticz?
Re: Upgrdae firmware of RaZberry using Domoticz
Posted: 18 Feb 2016 13:51
by pz1
I don't know, this is not a Domoticz forum. You better ask there, probably more knowledgeable people on that topic
Re: Upgrdae firmware of RaZberry using Domoticz
Posted: 18 Feb 2016 14:19
by Muckydevil
Hi Pz1,
ok thanks was hoping there was a command line tool etc.. but worse case I guess I could flash another SD card run the upgrade from there then swap cards over
Re: Upgrdae firmware of RaZberry using Domoticz
Posted: 18 Feb 2016 14:36
by pz1
Muckydevil wrote:Hi Pz1,
ok thanks was hoping there was a command line tool etc.. but worse case I guess I could flash another SD card run the upgrade from there then swap cards over
Well that is the fun of using Raspberry: Swapping cards! If necessary, you just fire-up a Zway installation to use its maintenance tools for your Zwave devices