I have about 10 "TKB Philio Z-Wave PIR, Door Window, Light and Temperature Sensor (4 in 1)" sensors.
I can add them and they work pretty much perfectly in Z-WAY however the motion sensor never turns off.
Everytime I walk in front of a sensor the time updates under "motion", this is always how these sensors have been, they never turn off, they just send an ON signal each time motion is triggered.
How can I set Z-WAY to turn off the motion sensor if motion is not detected for say 30 seconds?
Discussions about RaZberry - Z-Wave board for Raspberry computer
1 post • Page 1 of 1