[module] Foscam 8910W
Posted: 14 Mar 2016 10:09
Hi all,
I made a module to support the Foscam 8910W/8918W camera including control.
Create a user in camera ui, this user must be a Operator!
Upzip the folder in z-way-server/automation/modules
restart z-wave server
add the camera to z-wave ui and fill in ip and user that you created above.
save and you are ready.
When you update z-wave server, you have to install the folder again.
I made a module to support the Foscam 8910W/8918W camera including control.
Create a user in camera ui, this user must be a Operator!
Upzip the folder in z-way-server/automation/modules
restart z-wave server
add the camera to z-wave ui and fill in ip and user that you created above.
save and you are ready.
When you update z-wave server, you have to install the folder again.