forum

Hi,

Does anyone know how to get the Aeotec Door/Window Sensor 6 (ZW112-C) to work. It shows up as two sensors in the GUI but neither change state when the reed switch is activated?

Cheers
Ray

Wow, no one have one of these yet

Please show the log during device activation (reed switch switching)

Had the same problem with this device.

I had to set parameter 0x79 (121) to 3 (2 works as well), and now the 0.48.1 action updates reliably and immediatly when the door is opened/closed. The default setting of 1 (Basic Set CC) doesn't provide any feedback to z-way from what I could see in the logs.