How to do automation? I'm confused.
Posted: 24 Jul 2016 11:12
So I just recently got into Z-wave and have a Razberry up and running with be latest firmware. However I'm a bit confused about how to actually automate my devices.
The manual references a HA-interface where you can create scenes but this interface is apparently gone now according to the release notes. So what's the replacement? The default smarthome web interface doesn't seem to have any such capabilities. The only thing I've found is the If -> Then plugin but it's rather limited.
Are we supposed to rely on third party solutions for this now such as OpenHAB?
The manual references a HA-interface where you can create scenes but this interface is apparently gone now according to the release notes. So what's the replacement? The default smarthome web interface doesn't seem to have any such capabilities. The only thing I've found is the If -> Then plugin but it's rather limited.
Are we supposed to rely on third party solutions for this now such as OpenHAB?